Operator`s manual

EDGE ROUTING OR INTERNAL ROUTING

For ease of operation and Io matnia{n proper control, your router has !we handles.

end on sach side of the router base When operating the router, a_ways hold it [irmty

witl_ both hands {see Fig 16 and 16a )

Turn the router "On', let lhe motor build

to its lull speed, then gradually feed the

culter bit into the workpieCer ALWAYS

be alert and watch what you are doing

NEVER operate the router when yolJ

are fatigued

EDGE ROUTING (Figs,. 16 and 16a)

1 With depthoef-cut ssl, place router

on edge of workpiece, making sure

the cutter does not contact the

workplece {With plunge base, have

plunge acfion locked in the down

position and ready to cut)

2 Have an edge guide (board or

motet straightedge) ctamped ]n

place to help guide reuters base

when making your edge cut

3 Turn the fouler "On", and lel

lhe motor build Io its tuff speed

4 To begin your cut. gradually

leed the cutter bit into the edge

of the workptece

5 When cut is completed, turn

meier "Off" and fat cutter bit

come to a complete stop

before removing it from the

workpIsce

6 Unplug fouler from power

sou_-cs, piece fixed base router

upside down on worktable.

place plunge router on worktable.

and inspect finished cut in

workpiece

Fig, 16 --_ Feed Diredtion .,

Edging with Fixed Base

Fig 16a Feed

Edging w_th Plunge Base

Z_ WARNING: Always securely clamp your workpiece and keep a firm grip

on the router base with BOTH HANDS at all times. Failure to do so could resuff

In loss of control causing possible serious personal Injury

Z_ WARNING: Removing cutler bit from workptece while it ta still rotating

coutd damage workplece and result in loss of control, causing serious persona!

Injury