Operator`s manual

DEPTH_STOP ROD AND DEPTH-STOP TURRET (Figs. 10 end 11)

The Depth-Stop Rod end the Depth-Stop Turretare used to control the

cutting depthas follows:

Turn motor off and unplug frompower source

With the cuttingbit already Installed, lower the plunge action until the cutlerbit makes

contact wilh the flat, level surface fha router Is Wtllng on, Lock the plunge depth

locking laver (F), This position isZERO ="0" fromwhich further depth adjustments

can be made

To set a dsstred depth*ol-cul, rotate depth=stop lurret untit the Lowest step of the

turret (A) is a_lgned d}reetty under the Depth-Stop Rod (B) (see fig 1o)

Loosenthe Depth Rod Locking Knob and lower the depth-stop roduntil tt

contactsthe lowest step on the turret,

Slide the Clear Plastic Dopth*lndlcator (D) until the red line on the Indicalor Is linedup

withZERO - "O",marked tn black on the botlom of the depth scale, (ThisIs now the

Indicating point at which the bit makes conlaet with the workplace)

To set a desired cutting depth, slide the Depth-Stop Rod up untlf the Red Ltna

on the Clear Plaetlc Depth-Indicator p_

Depth Scale (E), Secure the

Depth-Slop Rod at this

position by tlghlen_ng the Depth

Rod Locking Knob

Unlock the Plunge Lock Lever (F) to

allow the bit to automaUceIly retract

to lhe up position

The desired depth-of-cut may now be

achieved by plunging the router down

unlit lhe depth-stop rodconlactsthe

seIeeted step on the depth-stop turret

Fig. 10

NOTE: When making depth adjustments on the plunge base, the motor c|smp I

shou d always be closed securely. l

17543