Operator`s manual

• ÷'l*l_ " _* [i'l'l'l'l'l'l'l'l'_t _ * • - •
Rating
No.load Speed
Peak HP
Input
Callers/Nuts and Cutter Shank Diameters
Fixed Base Diameler
Ptunge ,Base Diameter
......S,L!,b,:BaseOpening (Diameter let cutter bit use)
Sub-Base Thickness
FIxed Base Depth of Cut
Plunge Base Depth el Cut
11,0 Amps
12,00g - 25,000 RPM
2
120-volts, 60Hz AC
114-1n, l12*in,
64aches
6 _Via-inches
1IA-lnchBa (lot boih'bases) ......
0.23qnches {emm) (far botl'l bases)
t _t44nches (45ram)
2 V_,4nches (55ram)
I OTE:This too! Is shipped completely assembled.To change motor from one
base to the other_ tnstal_ or remove cutter bits, add accessories such as sawdust
ejection hoods for hook-up to vacs, or fnstatl the heavy-duty edge guide, see the
following instructions,
SELECTING THE C UTTER BIT
This router comes with It4-In and lt2-in coltots/nuls thai accept I14 and 1/2-fnch
diameter shank culter bifs
Z_ WARNING: Do not use router cutter bits that have e culler bit diameter
larger Ihan 1 V4-1nches as they will not fit through the sub-base opening, and
will cause damage to the sub-base_ the motor, and could cause serious personal
Injury to the operator.
NOTE; The sub*base Installed on the fixed and plunge bases In this kit have a
sub.base opening of 1 14-1nchea..To use cutting bits with a larger dtameler,
Install a sub-base with a larger opening, sold separately at Sears stores or other
Craftsman outlets,
Z_ WARNING: When using router cutter bits with a cutter diameter larger than
1 V2-1nches, ALWAYS have the speed dial set at number 1 or 2.. Refer to the
Vartabla Speed Selection Chart located on top cap of the motor housing for the
maximum speeds to use wtlh cutting bit dfamelers. Failure to follow these
instructions could cause loss of control of the router In the workplace, causing
possible serious personal Injury,
14