Owner`s manual

_k WARNING: Always wear safety gogglQsor
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resultinginpossible
seriousinjury.
WARNING: Do not allow familiarity withyour
trim saw to make you careless. Remember that a
carelessfraction ofa second is sufficientto inflict
severe injury.
CHARGING YOUR TRIM SAW
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you shouldcharge it untillighton front of
chargerchanges from red to green.
Note: Batteries will not reach full chargethe first time
they are charged. Allow several cycles (cuffing
followed by recharging) forthem to become fully
charged.
TO CHARGE
• Charge battery pack only with the charger
provided.
• Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
• Connect chargerto power supply.
• Place battery pack in charger aligningraised rib in
charger withgroove in battery pack.
• Pressdown on battery pack to be sure contacts on
battery pack engage properlywithcharger
contacts.
• Red lightshouldturn on. Red lightindicatesfast
charging mode.
If red lightis flashing, this indicatesbattery pack is
deeply dischargedor hot.
If battery pack is hot, red lightshould become
steady after battery pack has cooled down.
If battery pack is deeply discharged, red light
should become steady after voltage has increased,
normally within 30 minutes.
if after one hour red lightis stillflashing,this
indicatesa defective battery pack and should be
replaced.
Green lighton indicates battery pack is inslow
charging mode or fully charged.
Yellow lighton and red lightflashing indicates
defective battery pack. Return battery pack to your
nearest Sears Repair Center for checkingor
replacing.
• When your battery pack becomes fully charged, the
red lightwill turn OFF and the green lightwillturn
ON.
• If you remove batte_ pack from charger and
reinsert it immediately (less than 5 seconds)
back in charger, the green light will come on
indicating full charge and slow charging mode
until removed from charger. If you remove
battery pack from charger and wait more than 5
seconds before reinserUng it back in charger,
the charger will function normally.
• After normal usage, 1 hourof chargingtime is
requiredto be fully charged. A minimumcharge
time of 1-1/2 hours is requiredto rechargea
completely discharged tool.
• The battery pack willbecome slightlywarm to the
touch while charging. This is normal and does not
indicate a problem.
• DO NOT place charger in an area of extreme heat
or cold. It will work best at normal room
temperature.
_k CAUTION: Your battery pack containsspecial
hightemperature batteries to help prevent battery
damage when left on charge for extended periods
of time. However, once the batteries become fully
charged, w_ recommend that you unplugyour
charger from power supply.
_1 im
LED FUNCTION OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BA'I'rERY PACK:
• Red LED Lighted = Fast Charging Mode.
• Green LED Lighted = Slow Charging Mode and Fully Charged Battery Pack.
• Red LED Flashing = Hot or Deeply Discharged Battery Pack. Also Defective
Battery Pack After 1 Hour.
• Yellow LED Lightedand Red LED Flashing= Defective Battery Pack.
9