Owner`s manual

n When making a cut use steady, even pressure.
Never force cuts.
i Do not cut warped or wet lumber.
[] Always holdyour saw firmly with both hands and
keep your body in a balanced positionso as to
resist the forces of kickbackshould it occur.
_When using your saw, always stay alert and
exercise control. Do not remove your saw from
workpiece while the blade is moving.
DEPTH OF CUT ADJUSTMENT
Always keep correct blade depth setting.The correct
blade depth setting for all cuts should not exceed 1/4
inch below the material to be cut. More blade depth
will increase the chance of kickbackand cause the cut
to be rough. One blade tooth below the material to be
cut works best for most efficientcuttingaction.
TO ADJUST BLADE DEPTH
[] Remove battery pack from saw.
,_k WARNING: Failure to remove battery pack from
saw could result in accidentalstartingcausing
possible serious personal injury.
STARTING A CUT
Know the right way to use your saw.
See Figure 12.
RIGHT
Never use your saw as shown in figure 13,
Fig. 12
DEPTH
BASE ADJUSTMENT
ASSEMBLY KNOB
Fig. 11
[] Loosendepth adjustment knob. See Figure 11..
I Hold base fiat against the workpiece and raise or
lower saw untilthe required depth is reached.
[] Tighten depth adjustment knob securely.
WRONG
Fig. 13
Never place your hand on the workpiece behind
your saw while making a cut.
_IL WARNING: To make sawing easier and safer,
always maintainproper control of your saw. Loss
of control of your saw could cause an accident
resultingin possible seriousinjury.
13