Service Parts









▪Make sure drawers are fully closed.

▪ Insert the lockbar (which stores in the top tray), tabbed

end up, into the slot in the top tray and down into the slot

in the base.

▪ Close the cover and lock with the key.





Literature



Not all operation instructions will relate to your model.

• Empty the drawer.

• Fully extend the drawer.



 - Fully extend the drawer. Insert screwdriver

into the slot in the side and push in on the stop until it

clears the lance. Pull drawer just past lance before

releasing stop. Repeat the process for the other slide.

 - Depress the release tabs on both sides,

(this allows the slides to ride over the stops).

Pull out to remove.

- Lift or lower (depending on the slide) the

release lever on both sides (this allows the slides to ride

over the stops). Pull out to remove.





 Remove enough drawers to access the top and bottom

mounting surfaces of the units. Refer to drawer removal

instructions.

 Place the chest in the desired location on top of the cabi-

net or intermediate chest and mark the mounting hole

locations onto the cabinet top.

 Remove the chest and drill two 5/16" (8mm) holes

through the top of the cabinet or intermediate chest.

 Secure the units together using two 1/4 - 20 x 5/8"

screws and nuts at each joint.



• Reverse above procedure..

No hardware included.

Release