Use & Care Manual


 


▪ Insert the straight end of the lockbar into the slot in the
base.
▪ Move the lockbar toward the unit until the bent end ts
into the slot near the lock.
▪ Lock with the key.
NOTE: If your unit is equipped with a storage compartment
with a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.


3/8” wrench
Flat-tip Screwdriver
Caster pack

Literature
Hardware bag
Caster pack

• Remove bottom drawers. (See Operation Section, Part
B.)
• Lay the cabinet on its back. Use packaging material to
protect the nish.
• Mount both swivel casters on the same side of the unit
as the side handle.
• Attach the casters using (4) 1/4 - 20 x .438-in screws and
(4) 1/4 - 20 nuts per caster.
• Wrench tighten all screws. It is recommended not to
exceed 80 inch pounds of torque.
• Return the unit to its upright position.
• Reinstall bottom drawers.


1/4 - 20 x .438-in (Qty: 16)
1/4 - 20 Nut (Qty: 16)
Screwdriver
3/8-in Wrench

Not all operation instructions will relate to your model.


2
1/4-20 Hex Nut (Qty: 16)
1/4-20 x .438-in HW Screw (Qty: 16)
Screw
Nut