Product manual

A smaller wire gauge size has greater capacity than a larger number (14-gauge

wire has more capacity than 16-gauge wire; 12-gauge wire has more capac-

ity than 14-gauge). When in doubt, use the smaller number. When operating

a power tool outdoors, use an outdoor extension cord marked "W-A" or "W".

These cords are rated for outdoor use and reduce the risk of electric shock.

,_ CAUTION: Keep the extension cord clear of the working area. Position the

cord so that it will not get caught on lumber, tools, or other obstructions while

you are working with a power tool.

,_ WARNING: Check extension cords before each use. If damaged, replace

immediately. Never use a tool with a damaged cord, since touching the damaged

area could cause electrical shock, resulting in serious injury.

SAFETY SYMBOLS FOR YOUR TOOL

The label on your tool may include the following symbols.

V ...................................................... Volts

A....................................................... Amps

Hz ..................................................... Hertz

W...................................................... Watts

min ................................................... Minutes

"%' ............................................... Alternating current

---= .............................................. Direct current

no ................................................ No-load speed

[] .................................................. Class II construction, Double Insulated

.../min ............................................... Revolutions or Strokes per minute

.............................................. Indicates danger, warning or caution. It means

attention? Your safety is involved.

SERVICE SAFETY

• If any part of this router is missing or should break, bend, or fail in any way;

or should any electrical component fail to perform properly: shut off the

power switch, remove the router plug from the power source, and have the

missing, damaged or failed parts replaced before resuming operation.

• Tool service must be performed only at a Craftsman Parts and Repair

Center. Service or maintenance performed by unqualified personnel could

result in a risk of injury.

• Use only identical replacement parts when servicing a tool. Follow the

instructions in the maintenance section of this manual. Use of unauthorized

parts or failure to follow maintenance instructions may create a risk of electric

shock or injury.

28084 Manual Revised 07-0712 Page 7