Product manual

TO ADJUST DEPTH WITH DEPTH=ADJUSTMENT WRENCH (Figs. 37, 37a

and 37b) Fig. 37

NOTE: The Depth-Adjustment

Wrench supplied is used to

adjust the depth when the

router is fixed to the router

table (Model No. 320. 28180),

sold separately.

WARNING: Always read

and follow all directions for

mounting the router to a

router table and for use of the

router table.

WARNING: Always turn

the router motor off and

unplug the router from the

power source before making

any adjustments or installing

accessories. Failure to turn

router motor off and unplug

the router could result in

accidental starting, which can

cause serious personal injury.

_, WARNING: Only use

router tables with proper

guarding for the cutting bit

and with "on-board," switch-

controlled receptacles. Failure

Fig. 37a

to use router tables with appropriate safety features could result in serious

personal injury.

When using either the fixed base or D-handle base to attach the router to the

router table, the bit depth can be adjusted by turning the Micro Adjustment Dial

clockwise or counterclockwise with the wrench supplied. (Fig. 37 and Fig. 37a)

The depth of the cut can be read on the scale dial. Each mark on the scale

indicates a 1/64-in. change in depth setting.

1. Turn off the router.

2. Loosen the router motor clamp.

3. Insert the wrench into the adjusting hole on the tabletop. Turn the adjustment

bolt on the router clockwise with the wrench to move the collet/nut up, or

counterclockwise to move the collet/nut down.

28084 Manual Revised 07-0712 Page 49