Product manual

,_ WARNING: Removing the cutting bit from workpiece while it is still rotating
could damage the workpiece and result in loss of control, causing serious
personal injury.
NOTE: Making test cuts is essential with most routing applications. A test cut
will give a feel for the set-up, the router's speed, the depth of cut, and how the
cutting bit reacts to the workpiece.
FREEHAND ROUTING (Fig. 30)
,_ WARNING: Do not use
large cutting bits for freehand
routing. Using large cutting
bits when freehand routing
could cause loss of control
or create other hazardous
conditions that could result
in personal injury. If using a
router table, large bits should
be used for edging only.
When used freehand, the
router becomes a flexible and
versatile tool. This flexibility
makes it possible to easily
rout signs, relief sculptures, etc.
When freehand routing:
Fig. 30
1. Draw or layout the pattern on the workpiece.
2. Choose the appropriate bit.
3. Rout the pattern in two or more passes. Do not exceed 1/8-in. depth of cut in
a single pass. This will help provide better control, as well as serve as a guide
on the next passes.
NOTE: A core-box bit or V-groove bit is often used for routing letters and
engraving objects. Straight bits and ball mills are often used to make relief
carvings. Veining bits are used to carve small, intricate details.
NOTE: Making a single, deep cut is never advisable. Smaller-diameter bits are
easily broken by too much side thrust and torque. Larger bits will cause a rough
cut and be difficult to guide and control. For these reasons, do not exceed 1/8-
in. depth of cut in a single pass.
_. WARNING: Always securely clamp the workpiece in place, and keep a firm
grip on the router base with both hands at all times. Failure to do so could result
in loss of control causing possible serious personal injury.
28084 Manual Revised 07-0712 Page 41