Product manual

The speed charts above indicate the relationship between the speed setting and
the cutting application. Exact settings are determined through operator experience
and preference, and by recommendations by the cutting-bit manufacturer.
ELECTRONIC FEEDBACK CIRCUITRY
Electronic feedback circuitry monitors and adjusts power in order to maintain the
desired RPM for consistent performance and control, providing constant speed
under load for a quality finish in all materials
PLACING THE ROUTER ONTO THE WORKPIECE AND STARTING THE CUT
,_ WARNING: Before operating the router, follow all safety instructions in this
manual. Failure to do so could result in serious personal injury.
NOTE: Making test cuts is essential with most routing applications. A test cut
will give a feel for the set-up, the router's speed, the depth of cut, and how the
cutting bit reacts to the workpiece.
Much of routing is a trial-and-error process of making various adjustments, followed
by test cuts. To avoid ruining good material, make test cuts on scrap materials.
28084 Manual Revised 07-0712 Page 36