Product manual

Electronic Variable Speed Control (Fig. 23)
The electronic speed control Fig. 23
feature allows router motor
speed to be matched to cutter
size and workpiece-material
hardness for an improved
finish and extended bit life.
Speed changes are made by
rotating the Speed Control Dial
to the "LEFT," starting at "1 ,"
to increase the speed and to
the "RIGHT" to decrease the
speed, as indicated on the Dial.
The router motor top cap has
a "Variable Speed Selection
Chart" located above the "ON/OFF" toggle switch to help determine the correct
speed for the cutting bit being used.
WARNING: Before operating the router follow all safety instructions in this
manual. Failure to do so could result in serious personal injury.
Variable Speed Selection Chart
Never exceed these bit speeds
Cutting-Bit Diameter Max. Speed
Up to 1 in. (25mm) 6
1-1/4 in. to 2 in. (30-50mm) 4 - 5
2-1/4 in. to 2-1/2 in. (55-65 mm) 2 - 3
3 in. to 3-1/2 in. (75-90mm) 1 - 2
Reduce the speed when using extra large bits (1-inor more in cutting diameter
or heavy cutting bits. Changing the router's rate of feed can also improve the
quality of the cut.
DIAL SETTING
1
2
3
RPM
12,000
14,000
16,000
APPLICATION
Non-ferrous metal, hardwoods,
larger diameter cutting bits
4
5
6
18,000
20,000
25,000
Softwoods, plastics,
countertops, smaller diameter
cutting bits
28084 Manual Revised 07-0712 Page 35