Product manual

Deep Cuts (Fig. 20) Fig. 20
The proper cutting depth
for each pass is always
determined by the material,
the cutting bit size, and the
type and power of the motor.
Always make several,
progressively deeper cuts by
starting at one depth and then
making several more passes,
each time increasing the
cutting depth until the desired
depth is reached.
Making a cut that is too deep will stress the router motor and the cutting bit, and it
may burn the workpiece and dull the cutting bit. It could also "grab" too much of
the workpiece and cause loss of control of the router, causing a serious accident.
Always make test cuts in scrap material similar to the workpiece before
beginning the final cutting. Remember, knowing the right depth for each cut
comes with routing experience.
LED WORKLIGHTS (Fig. 21)
The router motor has 3 built-
in worklights located around
the collet/nut for high visibility
of workpiece when cutting.
These lights are always "ON"
when the toggle switch/trigger
switch is in the "ON" position,
Fig. 21
28084 Manual Revised 07-0712 Page 33