Product manual

6. Lock the Router Motor Clamp (A).
7. While continuing to press the Coarse Adjustment Knob (B), turn the Fine
Adjustment Dial (F) until the "0" (zero) mark on Depth Indicator Ring (E) is
lined up with the "1" mark on the base.
8. Release the Coarse Adjustment Knob, making sure that the "0" stays lined
up with the mark.
9. Place the router on two, level, scrap workpieces, positioned side by side with a
space between them so that the cutting bit can be lowered below the sub-base.
10. Turn the Fine Adjustment Dial (F) counterclockwise to lower the bit to the
desired depth of cut. Turn the dial clockwise to raise the cutting bit.
11. Once the depth of cut is set, securely close the router motor clamp (A).
NOTE: Making a single deep cut is never advisable. Small-diameter cutting bits
are easily broken by too much side thrust and torque. Large cutting bits will
cause a rough cut and be difficult to guide and control. For these reasons, do not
exceed 1/8-in. depth of cut in a single pass.
DEPTH ADJUSTMENT WITH THE PLUNGE BASE
_, WARNING: The router should never be turned ON or be connected to the
power source when you are assembling parts, making adjustments, installing
or removing collets/nuts or cutting bits, cleaning, or when it is not in use.
Disconnecting the router will prevent accidental starting, which could cause
serious personal injury.
28084 ManuaLRevised 07-0712 Page 28