Product manual

DEPTH ADJUSTMENT WiTH FIXED BASE (Figs. 13 and 14)

The fixed base is designed Fig. 13

with a micrometer-fine

adjustment system. When

the bit is lowered to the

approximate position desired

(coarse setting), the system

may then be micro adjusted to E

the precise depth desired.

Coarse Adjustment:

Depressing the Coarse

Adjustment Knob (B) allows

you to quickly lower or raise

the cutting bit to one of three

depth settings.

Fig. 14

Fine Adjustments:

NOTE: Before making fine

adjustments, reset the Depth E

Indicator Ring to "0" (zero) B._

(E, Fig. 9).

The Depth Indicator Ring (E),

located on the Fine Adjustment

Dial (F, Fig. 9) is marked in

1/64-in. increments. Turning

the fine adjustment dial

clockwise 180 ° (1/2 turn),

lowers the cutting bit 1/16

inch. One full turn clockwise (360) to "0" (zero) lowers the bit 1/8 in.

The Depth Indicator Ring may be reset to "0" (zero) without moving the Fine

Adjustment Dial. This allows the user to begin adjustments from any reference point.

To Adjust Cutting Depth (Figs. 13 and 14)

1. Turn the router motor off and unplug it from the power source.

2. Place the router on a flat, level surface with the back of the fixed base facing

you. Open the Router Motor Clamp (A).

3. With the cutting bit installed, press in the Coarse Adjustment Knob (B).

4. Lower the router motor into the base until the cutting bit is very close to the

surface on which the base is sitting.

5. Turn the Fine Adjustment Dial (F) until the cutting bit just touches the flat

surface on which the base is sitting.

28084 Manual Revised 07-0712 Page 27