Product manual

5. Set the router motor upside down on its top cap with the collet/nut pointing

up, and remove the cutting bit.

6. Store the router motor and base in the carry/storage case when not in use.

To Remove Router Motor From Plunge Base (see Fig. 10)

1. Turn the router motor off and unplug the router from the power source.

2. Place the router on a flat surface.

3. With the back of the plunge base facing you, open the router-motor clamp (A)

and make sure that the plunge action is in the "UP" position with the plunge

lock lever (B) locked down.

4. Lift the router motor straight up and out of the base, sliding the pin in the

router motor free from the slot in the plunge base.

5. Set the router motor upside down on its top cap with the collet/nut pointing

up, and remove the bit.

6. Store the router motor and base in the carry/storage case when not in use.

To Remove Router Motor From D=handle Base (see Fig. 11)

1. Turn the router motor off Fig. 11

and unplug the router from

the power source.

2. Place the router (D-

handle base/router

motor) on flat surface.

3. With the back of router

facing you, open the

router motor clamp (A).

4. Push in the coarse

adjustment knob (B) to

release the router motor

"Position groove" (C) from

the lock hook (D) in the base, while lifting router motor free of base.

5. Set the router motor upside down on its top cap with the collet pointing up

and remove the cutting bit.

6. Store the router motor and base in the carry/storage case when not in use.

28084 Manual Revised 07-0712 Page 25