Product manual

CUTTING BITS

Get faster, more accurate cutting results by keeping cutting bits clean and sharp.

1. Remove all accumulated pitch and gum from cutting bits after each use.

2. When sharpening cutting bits, sharpen only the inside of the cutting edge.

Never grind the outside diameter.

3. Be sure, when sharpening the end of a cutting bit, to grind so that the

clearance angle remains the same as it was originally.

iNSTALLiNG AND REMOVING THE ROUTER MOTOR

,_ WARNING: Never use the router motor without installing it into either the

fixed, plunge, or D-handle bases in this Router Combo. Failure to do so could

result in serious personal injury and damage to the motor.

NOTE: Install the collet/nut and router cutting bit you are going to use before

installing the router motor in the fixed base, plunge base or D-handle base. See

"Installing and Removing the Cutting Bit" section.

WARNING: Always turn the router motor off and unplug the router from the

power source before making any adjustments or installing accessories. Failure to

turn the router motor off and unplug the router could result in accidental starting,

which can cause serious personal injury.

To Install Router Motor in Fixed Base (Fig. 9)

1. Turn the router motor off Fig. 9

and unplug the router from

the power source.

Place the fixed base on

flat surface.

With the back of the fixed

base facing you, open the

router motor clamp (A).

Press in the Coarse

Adjustment Knob (B) while

aligning the router motor's

slot with the pin in the

fixed base.

When the motor's slot is aligned and engaged into the base's pin, slide the

router motor down into the fixed base.

When the coarse-adjustment knob is pressed in, the router motor can be

moved up or down to set coarse adjustments.

After all adjustments are made, securely close the router-motor clamp.

28084 Manual Revised 07-0712 Page 23