Product manual

SELECTING THE CUTTING BiT
This router comes with 1/4-in. and 1/2-in. collets/nuts that accept 1A-inch-
diameter and 1/2-inch-diameter shanked cutting bits, respectively.
,_ WARNING: Do not use router cutting bits that have a cutting-bit diameter
larger than 1-I/4 inches when using the router with the sub-bases included with
this combo, as they will not fit through the sub-base opening and will cause
damage to the sub-base and the motor and could cause serious personal injury
to the operator.
NOTE: The sub-base installed on this router has an opening of 14/4-inches. To
use cutting bits with a larger diameter, use a sub-base with a larger opening,
sold separately at Sears stores or other Craftsman outlets.
WARNING: When using router cutting bits with a cutter diameter larger
than 1-1/2 inches, always have the speed dial set at number 1 or 2. Refer to the
Variable Speed Selection Chart located on top cap of the router motor for the
maximum speeds to use with various cutting-bit diameters. Failure to follow
these instructions could cause loss of control of the router in the workpiece,
causing possibly serious personal injury.
28084 ManuaLRevised 07-0712 Page 20