Instruction manual

!, Screwthe small endof clamp rod into threadedhole m clamp
ptateuntil the platebottoms on its shoulder (makesure clamp
plate is orientedsuch that letter "C" is facing outwardsas shown
in Fig,//7).
2. Tightlysecureclamp plateto clamp rod using_" helical lock
washerand a hex nut.
3, Insert the oppositethreadedendof clamp rod through hole in
pushblock, and installa flat washeranda wing nut on to it.
ROUTERVIBRATIONSSOMETIMESCAN
CAUSE1/4-28 HEXNUTANOCLAMP
PLATETOGETLOOSEtPERIODICALLYCHECKFASTENERSAND
CLAMPPLATETOMAKESURETHEYARETIGHTANDSECURE.
, NUT
i[ CLAMPPLATE-
RGURE F
i
'FLAT WASHER
" PUSH BLOCK
ASSEMBLYOF BLOCK& GUARDTO
UNITIZED
Clampplate,whenfree,tries to swing in the directionof arrow
(SeeFig.#8) due to its weight.
t. Mount push blockassemblyon the unitizedfenceby supporting
clampplateagainstthe face of the fenceand aligning retaining rib
on push blockwith thegroove in the faceof unitizedfence,
2. Slide push blockassemblybackand forth alongentirelengthof
unitizedfenceto seethat it slidesfreely.
NOTE:a, Removedustand chips from sliding surfacesof push
blockand unitizedfenceas neededto maintaingood
sliding motion.
b, Occasionalapplicationof furniturespray wax on sliding
surfacesof PUSHBLOCKONLYwilt greatly in]provethe
sliding motion,
FORROUTINGON ENDS(TENONS,SLIDINGDOVETAILS,ETC,)
WORKPIECEIS HELDAGAINSTFACEOFUNITIZEDFENCEAND
CLAMPEDBETWEENCLAMPPLATEANDSURFACE'S'OFPUSH
BLOCK.SEEFIG.#8.
FIGURE8
1. Assembleguardto unitizedfenceasshown in Fig,#9,
2. While holdingthe guardat a slight angle,asshown, inserttab
on onesideof guardinto the holeinside the slot on the fence.
3, Hold the guard againstthis slot, straighten it into avertical
position,and insert the oppositetab into the matingslot.
SeeFig,#9.
4, Pivotguardbackand forth a fewtimes to makesure that it
movesfreely.
NOTE:Oncethe guard has beeninstalled,do nol removeit for any
reason,
FIGURE9
8