Instruction manual

ASSEMBLYOF EXTENSIONSANDLEGS
t. Toassemblethe EXTENSIONSand LEGSto ROUTERTABLE,
placetable,top side down, on a smooth, flat surfi_ce,and position
the LEGSand EXTENSIONSrelativeto the TABLEas shown in
Figure1. htsert the #10-32 x Yi'screwthrough the LEGand install
lock washerandnut. This is to bedone for eachtable leg.
2, Makesure all screws andnuts aresecurelytightened,
3. Turnthe tabletop side up andcheckto see that tfm
EXTENSIONSare evenwith or slightly belowthe table top.
4, In no caseshould the EXTENSIONSbehigher thanthe table, or
elsetheymay interferewith the workpieceduring routing causing
a conditionthat canresultin possibleserious injury.
5. If the extensionsarehigherthan the top of the table, loosenthe
screwsholding theEXTENSIONSand repositionthem so they art;
evenwith or slightly lower than the top of table, SECURELY
TIGHTENALL SCREWSANDNUTSAGAIN,
6. To doublecheck,slide a flat pieceof woodalong thetop of the
tableboth directions,Makesurethat the end of the wood moves
freelywithout contactingthe edgeof the EXTENSIONnextto table,
DONOTPLACEHEAVYOBJECTSORPRESS
HEAVILYONTHEEXTENSIONSORELSE
THEYMAYBEDAMAGEDCAUSINGA CONDITIONTHATMAY
CANRESULTIN POSSIBLESERIOUS80DtLYINJURYDURING
ROUTING.
FIGURE 1
MOUNTINGROUTERTO TABLE
ALWAYSUNPLUGROUTERBEFOREMOUNTING(The tablewill acceptCraftsman3 hole 6 in. diameterbase).
, i:f •
1. Removethe router baseplate(back plate)from the router. '
2. While holding the router upsidedown, position it to the
undersidewithin the centerring of the table top, as shown in
Fig.#2,
3. Rotatethe router until the three mountingholes in the router
baselineup with threeof the holesin the table top (It will be
helpfulif you orient the router suchthat you can easilyreachthe
ON/OFFswitch from the front of the table.Craftsman_-25183
RouterTableSwitch PackageprovideseasyaccesstoON/OFF
button).
4. Insert three #!0-32 x _" longflat headmachinescrews
(provided) through holes in the tabletop (SeeFig,#2) and tighten
securelyinto the router base.
FIGURE2
5