Instruction manual

INTRODUCTION
Howoften haveyou neededa largeguiding surfaceon a routertable?YourCraftsmanRouterTablewith UnitizedFencecomes with ttle
following:
• A unique4" high unitizedfencedesignedto assist end grain
routing for makingtenons, sliding dovetailsandtongue and
groovejoints along with most edgeand facecutting operations.
• A speciallydesignedpush blockwith quick clamp for back up
and clampingboardsup to 4"width for endgrain routing.
• An accurateand quick adjustingjointing fenceadjustableto
properjointing depthof cut.
• Reversingfeatureof unitizedfencedesignedto enablerouting
operationslikegrooving,fluting, veining andcrown molding etc.
up to 2_" awayfrom the edgetowardsthemid,die ofthe board.
• Twoguardsfor operationon eitherside of ihe unitizedfence.
• Dust co!lectingattachmentfor most sllop vacuum hook ups,
• Extensionsthat providea largework surface.
If orderto facilitatehandlingand minimizeany damagethat might occur during shipment,your newroutertableis packaged
unassembled.We knowyou are anxiousto seewhat yOurnew too! wil! do, but a few minutes spent now carefullyreadingthe following
instructionswill result in lessfrustration and more enjoyableoperation later,
Startbycheckingandaccountingfor all the looseparts,If any partsare missing,contact your local Craftsmanretail or hardwarestore
outletfor replacement.
OPTIONALROUTERTABLEACCESSORIES
#25326CRAFTSMANUNIVERSALADAPTERPLATE,for mounting non-Craftsman1/4"shank routersto Craftsmanrouter accessories.
#25183CRAFTSMANROUTERTABLEPOWERSWITCH,for turning router and other accessories"on" and"off" from the front of the
router table, i
#25468CRAFTSMANGUIDEMASTERRouterTablePushShoe,aids in push shoe and hold down operations,accuratemeasurementand
router table setup,transforms into a miter gauge,and givesquick set up for 1/2" sliding dovetailjoints.
#25489CRAFTSMANROUTERTABLEFLOORSTAND,placesrouter tablesat convenientworking height,has adjustablefloor levelers,
andtwo steelshelvesfor storage,
UNPACKINGANDCHECKINGCONTENTS
Referto PartsList on Page16
YOUMUST READANDUNDERSTANDALLTHEINSTRUCTIONSCOMPLETELYBEFOREATTEMPTINGTO
ASSEMBLEANDOPERATEYOURROUTER/ROUTERTABLE,
TOOLSREQUIRED
, A smalland medium sizescrewdriver.
• A small or medium sizeadjustablewrench,
• An electricalor hand drill with 1/8"drill bit,
• Hammer