Instruction manual

4. Raiseor lower the _outeruntil top cutting edg(_cf bd _,.__f!:(m,}d
with line 'B. (Referto your router ownel's !rla,llual hji' adjusliq_ I
your router proper}y).AFTERMAKINGTHISAOJUS:rMENT,i-3E:
SURETHATROUTERIS SECURELYTIGHTENEDtN ]HE ROUTER
BASE,BITtS SECURELYTIGHTENEDIN THEROUTEF_CHUCK,
ANDROUTERBASEIS 1tGHTLYSECUREDTO TABLETOK
5, Removethe boardflora the fence,
WHENADJUSTINGHEIGHTOFROUTER
BITFORANYDESIREDCUT,MAKE
ABSOLUTELYCERTAINTHATTOPOFBITIS BELOWTHEINSIDE
SURFACEOFRETRACTABLEGUARD,ASSHOWNIN FIG. #16,
CHECKTO SEETHATGUARDRETRACTSFREELYIN ANDOUTOF
FENCETOITS NORMALPOSITIONOVERTHEROUTERTABLE
HOLE, DONOTOPERATEROUTERIF ANYPARTOFTHEBIT
CONTACTSTHEGUARD.
NOTE:The proceduredescribedaboveis intendedto providea
wayof retractingand holdingthe guard to havefull accessto the
_outerbit for makingadjustment&Workpieceto be routed could
besubstitutedfor thescrap boardfor makingadjustmertts.
For maximumstrengthand accuracy,boards to be joinedtogether
should be smooth andtrue. Theedgesshould be true to the (90°)
workpiecesurface,You cantruethe edgesof workpieceon your
router table using a straight bit.
!, Checkto see if faceof jointing fence is flush with thefaceof
unitizedfence, If not, loosensmall knob on jointing fenceand
push jointing fenceinside the cavity in unitizedfence.Tightenknob
on jointiag fence.
NOTE:The jointing fenceprovidesa continuous support for the
workpiece,as it is fed beyondthe router bit, tt compensatesfor
the amount of materialremovedby the router bit,
2. Adjustdepthof cut (materialyou want to remove)and router bit
l]eightas describedbeforefor Fig,#!5, Tightly securethe fence
andthe routerasdescribedbefore.(MAKESUREROUTERIS
UNPLUGGEDWHENMAKINGADJUSTMENTS.)
3. Checkyour adjustmentsby turningthe router 'ON'and feeding
a pieceof scrapwood a few inchesbeyondrouter b_t.Thenstop
andturn router 'OFF',
NOTE:Feedwork in the directionof arrow shown on labelon the
frontside of unitizedfence(whenfacingtable front).
4, Loosenknob on jointing fenceandmove it out flush againsti:l]e
finishededgeof scrapwood, Retightenthe knob SeeFig _17.
5. Repealthe test cut on the scrapwood.
6. Therouter table is now readyfor use,
NOTE:For bestjointing results,takevery shallowcuts _--/;:,"or
less.
1. Positionthe jointingfence suchthat its faceis flush with the
faceof unitizedfence.Tightensmall knob on jointing fence.See
Fig,#! 8,
fIGUREt6
FIGURE17
RGURE t8
11