Manual

7. Secureflangekeeperremovedearlierwithlocknutsandscrews.
Tightendownnutssecuringtheothertwo flangekeepers.See
Figure5.
8. If notalreadydone,slip the cablesthatrun fromthe handle
panelto the dischargechuteintothe cableguidelocatedontop
of the engine.SeeFigure4.
9. If notalreadydone,wrapthe wire of the headlampwire harness
down the righthandleuntil thewire canbe pluggedintothe
enginealternatorwireconnectordownontheengine.
10. Normallythe cableties holdingthesteeringcablesagainstthe
handlearelooselyinstalledoneachside ofthe lowerhandleat
the factory.Pullthecable tiestightto secure.Cutthe excess
fromthe endsof cable ties.
The extensioncord is fastenedwitha cabletieto therearof theauger
housingfor shippingpurposes.Cutthe cabletie andremoveit before
operatingthesnowthrower.
1/
ii
..............
SET-UP
Chute Clean-Out Tool
Achute clean-out tool is fastenedto the top ofthe augerhousing
witha mountingclip.SeeFigure6.The tool is designedto cleara
chuteassemblyof ice andsnow.Thisitemisfastenedwitha cabletie
at the factory.Cutthe cabletie beforeoperatingthe snowthrower.
Drift Cutters
1. Removethe twoscrewsand locknutsthat secureeachdrift
cutter,andremovethemfromthesidesof the augerhousing.
2. Turnthe drift cuttersaroundandpositionthemasshownin Figure
7 to the outsideof the augerhousing.
3. Attachthe driftcutterswiththe screwsandlocknutsremoved
earlier.
Figure4
\
Figure5
:hule Clean-out Tool
Figure7
9
Figure6