6” Buffer 241-1450
• Use recommended accessories. Use of improper accessories may cause risk of injury to persons. • Do not overtighten wheel nut. Replace defective wheel immediately. Use only flanges supplied with the buffer. • Handle the workpiece correctly. POWER SOURCE WARNING: Do not connect buffer to the power source until all assembly steps have been completed. The motor is designed for operation on the voltage and frequency specified.
SPECIFICATIONS A temporary 3-prong to 2-prong grounding adapter (see Figure 2) is available for connecting plugs to a two pole outlet if it is properly grounded. Make Sure Grounding Lug This Is Adapter Connected 3-Prong Plug To A Known Ground Figure 2 - 2-Prong Receptacle with Adapter MODEL 241-1450 6“ BUFFER The buffer is assembled with motor and wiring installed as an integral part of the tool. Horsepower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/4 Voltage . . .
• The threads on the right side of the buffer (facing unit) are right hand; threads on the left side are left hand. Hold the wheels firmly to loosen the hex nut. MAINTENANCE • Replacement wheels must have a minimum rated speed of 3450 RPM. • Make sure hex nuts are tight and snug against the outer wheel flange prior to restarting buffer. • Maximum wheel diameter for Model No. 241-1450 is 6 “. • Disconnect unit from power source before replacing buffing wheels or before performing any maintenance work.
Model 241-1450 Figure 3 - Replacement Parts Illustration for 6” Buffer 6
