Owner`s manual

INSTALLING TABLE LEG INSERTS IN THE TABLE LEGS

TABLE LEG INSERTS (FIGURE 10)

The router table includes two table leg inserts:

• Router bit storage panel for convenient bit storage

• Cover panel

If the table leg inserts have not been installed on the

router table legs, proceed as follows:

1. Place the table leg insert into the opening in the

table leg so that it is positioned at the very top of

the opening.

2. Press the insert in so that it is completely flush

with the leg.

3. Push the insert down as far as it will go to lock it

in place.

Figure 10

h wn

ASSEMBLING THE MITER GAUGE

ASSEMBLE THE MITER GAUGE

(FIGURE 11A AND FIGURE 11B)

1, Assemble the protractor head to the miter bar, as

shown in Figure 11A, using a #10-16 x 1/2" long

type BT pan-head self-tapping screw (33).

2. Tighten the self-tapping screw into the protractor

head so that the screw touches the miter bar but

still provides resistance when the protractor head

is rotated.

NOTE: the screw will resist turning when being

threaded into the hole as the screw is cutting

and forming a thread in the protractor head,

3. Assemble the knob, the 13/64" ID x 9/16" OD x

.040" thick washer (39), and the #10-24 x 7/8"

carriage bolt (41) to the miter bar and protractor

head as shown in Figure 11B.

4. TIGHTEN the knob SECURELY.

Figure 11A

-__ #10-16 x 1/2"

self-tapping screw

, Miter bar

ro, aotor

Figure 11B

Small clamping

knob

_ _ Washer

Protractor

#10-24 x 7/8"

\, carriage bolt