Operating instructions

THE FLOOR STAND AND THE ROUTER TABLE
As can be seen in the LEG
NOTE
ILLUSTRATION, there are four holes along the
edges of the leg. These are for use on a future
accessory product for the floor stand.
LEG ILLUSTRATION
ACCESSORY
HC=ES
r
ACCESSORY
,J HOLES
J
/
J
J
i -_
/ /
/
/
/-
./
° l
. /
.g/Z
The following procedure is easier to carry out if two
people perform the task.
1. Lay the shelf, top side down, on a workbench or
other sturdy surface, so that two of the corners along
the long length of the shelf overhang the workbench,
as shown in Figure 5.
I I The placement of a weight on the
I
NOTE
shelf, as shown in Figure 5, is strongly recommended
so that the shelf will maintain its position on the work-
bench and will not tip and fall off the workbench while
assembling the legs to the shelf.
FIGURE 5
-- "10 32 X " 2" _ONG
Tquss _E_'D MACHINE
SCREW _,CAL)
WORKBENCH_ ............. ,
/ -- "!032 HEX ,',EroS- NUT
'TYPICAL_
PLACE _
WEIGHT _-
_r _.... - -- FLOOR
....... r , _. "" STAND LEG
SHELF
_LOOR
2. Assemble a leg to one of the corners of the shelf
using four #10-32 x 1/2" long truss head machine
screws and #10-32 hex KEPS" nuts, as shown in
Figure 5.
3. Assemble a second leg in the same manner,
4. Lay the partially assembled floor stand on its side
on the floor so that the legs support the floor stand.
as shown in Figure 6.
FIGURE 6
;_C3 P_S-._'4- -- -
S
I
TRU'_S HEAD LtAC_ ",E '\ '_o /
..... ".L.
/
/
• 10 32 HEX KE_S X_T _/
_TYRICAL) z- LOWER
' SHELF
C
/
"k_FLOO,
5. Assemble the remaining legs to the shelf using
four//10-32 x 1/2" long truss head machine screws
and #10-32 hex "KEPS" nuts, as shown in Figure 6.
6. SECURELY TIGHTEN ALL FASTENERS.
7. Assemble a leveling foot to each of the leveling
brackets, as shown in Figure 7.
FIGURE 7
!
f
LEVELING
r_ /_/ BRACKET
t
\
t
8. Assemble the leveling brackets to each of the
floor stand legs using three #10-32 x 1/2" long truss
head machine screws and three #10-32 hex "KEPS"
nuts, as shown in Figure 8.