Operating instructions

I NOTE I For ALL routing operations
requiring use of miter gauge along with the fence,
be sure to align fence with miter bar slot before
making any cuts. Refer to the section, FENCE, on
Page 11.
Miters can be cut by loosening the protractor head
knob, turning the protractor head up to 60° in
either direction and retightening the protractor
head knob.
,_WARNING]
oThe GUARD MUST BE DOWN in the OPERATING
POSITION when using the miter gauge.
oAlways HOLD the workpiece FIRMLY and
SECURELY AGAINST the miter gauge, the router
table and the fence when making this cut.
• Make sure that NEITHER YOUR FINGERS,
HANDS, NOR ANY OTHER PART OF YOUR BODY
is in line with the router bit when using the miter
gauge, or serious bodily injury can occur.
26