Operating instructions

FIGURE21
Other Brands of Routers
It will be necessary for you to purchase a
Craftsman Professional Router Adapter Plate,
(9-25333), from your local Sears Retail Outlet or
through the Sears Catalogue.
Routers with a total overall height of 13 inches or
less and a base diameter of 7 inches or less can be
accommodated.
ROUTER POWER CORD TO THE SWITCH
,_.WARNING
• Make sure that the power cord from the switch box
IS NOT PLUGGED into an electrical outlet while per-
forming the following tasks. If it is plugged in.
UNPLUG it.
o MAKE SURE THAT ROUTER SWITCH IS IN THE
OFF pOSITION.
1. Plug the router power cord into one of the outlets
on the switch box.
2. Form the excess power cord into a coil.
3. Wrap two pieces of friction tape or strong cord
around the coil at opposite sides of the coil.
4. Allow some slack so that the cord does not
become stretched when it is plugged into the switch
box.
5. If desired, at this time plug the power cord from an
accessory, such as a web'dry vac or light, into the
other outlet.
[ ,WARNING]
• DO NOT plug the power cord from the router into
an electrical outlet AT THIS TIME.
• It WILL be necessary to use an extension cord
because of the short cord on the switch box. Refer
to the upcoming section. ELECTRICAL REQUIRE-
MENTS, under USING THE SWITCH for cord
specifications.
• Make sure that power cords from the router, acces-
sories, the switch box. and the extension cord DO
NOT and CANNOT COME IN CONTACT with the
router or any moving parts of the router.
° Make sure that power cords from the router, acces-
sories, the switch box, and the extension cord D©
NOT and CANNOT INTERFERE with any routing
operation or come in contact with the workpiece.
-. The power cord from the router is to be plugged
into the electrical outlet only AFTER the setup for
your routing operation has been completed.
• Refer to the upcoming section. SWITCH BOX
OPERATION. on Page 18.
• Refer to the upcoming section. USING THE
ROUTER TABLE. on Page 20_
15