Operating instructions

d. Press the second pushnut onto the other end of
the overhead guard pivot pin in the same manner
as in Step a.
e. Move the overhead guard up and down a few
times to ensure that it moves freely.
tA/LLLWARNING J Once the overhead guard has
been assembled to the fence, DO NOT remove it for
any reason. Its removal can result in an unsafe oper-
ating condition that can result in possible bodily injury.
PUSH BLOCK ASSEMBLY TO THE ROUTER TABLE
FENCE
FIGURE 16
1. Position the clamp plate relative to the push block,
as shown in Figure I6.
2. Align the rib and the V-shaped portion of the push
block with both the groove in the front of the fence
and the V-shaped portion of the fence.
3. Assemble the push block to the fence as shown in
Figure 16. The push block should move freely along the
full length of the fence when the guard is in the UP
position.
NOTE J
1. It is a good practice to frequently remove the dust
and chips that accumulate in use from the sliding
surfaces of the fence and the push block, and from
the groove in the fence.
2. The occasional application of a very light coating
of furniture wax to the SLIDING SURFACES ONLY,
of the push block, will improve the sliding action.
MITER GAUGE
1. Assemble the protractor head to the miter bar, as
shown in Figure 17. using a #10-32 x 1/2" long truss
head machine screw.
FIGURE 17
"0 32 X ' 2- LCNG
._S -'qUSS "EA3 MACMr-,E SCP_E¢,
M_TER BA,q- --USE -_'2 '40LE
i "'o o ,.j>
NOTE ] There are two round holes in the
miter bar. Make sure the truss head screw enters the
correct hole shown.
2. Tighten truss head screw into the protractor head
so that the wcrew head just touches the miter bar but
still provides a resistance when the protractor head
is rotated.
3. Assemble the knob, the 3/16" I.D. x 9/16" O.D. x
.040" thick washer and the #10-24 x 3/4" long round
head square neck bolt to the miter bar and protractor
head, as shown in Figure !8.
FIGURE 18
KNOB _ _%//--
_1_ :4 40 X 3 4" LONG
=JNHEAD MACHINE SCREW
3:16"1.D X 9:16"O D _ _/,,_-,
X .040- THICK WASHE= _
,,-7%-
i r4 40 HEX
Tg%gg¢oSOUARE
4. Assemble the miter pointer to the miter bar using
the #4-40 x 3/4" long panhead machine screw and
the #4-40 hex machine screw nut. Make sure the
miter pointer POINTS in the right direction.
5. TIGHTEN screw and nut SECURELY
13