Operating instructions

FIGURE 8
_E_ELING
LEVEL!NG //-- _,:©_
" _"_ _ ":C 32 × ! 2 -C';G
j_'["
Sg_E,',
,1032 HEX KEPS _'_gT_'_'i -_ .
:" .::, :..%
FLOOR STAND LEG
\ 4',
\
9. Set the router table top side down on the floor as
shown in Figure 9. At this stage in the procedure,
employing a second person to aid you in holding
the router table and the floor stand in place is
strongly recommended•
FIGURE 9
LOWER
• , ,._ SHELF , . _ - :_r2OR _<T-_'ID LEG
• i
• • * -- :'0 32 _E: _, KEPS NUT
." . T,,p_CL L
), //--:uPPER SHELF
,_ t * /
"".._ _ =:O 32 X i 2 LONG
- / TqUSS HEAD MACHh"4E SC_E,',
• [ TYPICAL
_, _ ,,_ ROUTER TABLE LEG
ROCTEB TABLE_ _ "_ S,',:TC _
10. Position the floor stand on the router table legs,
as shown in Figure 9.
11. Set the upper shelf on the floor stand legs, as
shown in Figure 9.
12. Line up the holes in the floor stand leg and the
upper shelf with the corresponding holes in the router
table legs.
I I Inserting a nail with a large head
I
NOTE
through one of the holes at each of the four corners
of the lower shelf will aid you in maintaining part
alignment. (The truss head machine screws may
also be used.) The nails (or screws) are removed
from the holes when the truss head machine screws
are assembled as described in the next step.
It may be necessary, to loosen the fasteners holding
the legs to the table in order to make the holes in
table legs line up with the holes in the shelf and the
holes in the floor stand legs. and so the table legs
can be made to lie fiat on the floor stand legs.
13. Assemble a ,_I0-32 x 1/2" long truss head
machine screw and #10-32 hex "KEPS" nut at each
of the holes, as shown in the Figure 9, Assembly
Detail. ORIENTATION OF THE FASTENERS MUST
BE AS SHOWN.
FIGURE 9, ASSEMBLY DETAIL
//./"
f'" _ =_ 12 _, <E_a - -
._ //- _ :.C._ _
• /
e ,
__- .. . .
UPPER S_EL_ _
_LCOR STANC -E2_
_._f/ '¢_:- ".E _ Z:E.'.
:_E"-2_- 2--: L _E.2
14. SECURELY TIGHTEN ALL FASTENERS.
INCLUDING THOSE HOLDING THE LEGS TO THE
ROUTER TABLE.
15. Set the floor stand right side up on the floor, as
shown in Figure 10.
FIGURE 10
16.
Adjust the leveling feet by:
a. loosening the screws holding leveling bracket
to leg,
b. adjusting the height,
c. retightening the screws until the floor stand is
firmly supported by the floor and does not rock
back and forth.
17. It may be necessary for you to do this any time
the floor stand and router table are moved.
10