Owner`s manual

17
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Disconnect ALL electric and battery power BEFORE
performing ANY service or maintenance.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a
closing garage door:
• Install door control within sight of garage door, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
• NEVER permit children to operate or play with door control
push buttons or remote controls.
• Activate door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of closing garage door.
INSTALLATION STEP 6
Install the Door Control
Locate door control within sight of door, at a minimum height of 5
feet (1.5 m) where small children cannot reach, away from moving
parts of door and door hardware.
1. Strip 1/4" (6 mm) of insulation from one end of bell wire and
connect to the two screw terminals on back of door control by
color: white wire to 2 and white/red wire to the 1.
2. Fasten the door control button securely with 6ABx1-1/2" screws.
If installing into drywall, drill 5/32" holes and use the anchors
provided.
3. Run bell wire up wall and across ceiling to motor unit. Use
insulated staples to secure wire in several places. Do not pierce
wire with a staple, creating a short or open circuit.
4. Connect the bell wire to the quick-connect terminals on the
motor unit panel: white to white; white/red to red.
5. Position the antenna wire as shown.
6. Use tacks or staples to permanently attach entrapment warning
label to wall near door control, and manual release/safety
reverse test label in a prominent location on inside of garage
door.
NOTE: DO NOT connect power and operate opener at this time.
The trolley will travel to the full open position but will not return to
the close position until the sensor beam is connected and properly
aligned.
HARDWARE SHOWN ACTUAL SIZE
Screw 6ABx1-1/2"
Lighted Door Control Button
Insulated
Staples
Drywall Anchors
Top
Mounting
Hole
Terminal
Screws
Bottom
Mounting
Hole
(BACK VIEW)
Bell
Wire
Lighted Push
Button
Bell Wire
DOOR CONTROL BUTTON
Red GreyWhite
Door Controll
Connections
To release or insert wire,
push in tab with
screwdriver tip
Strip wire 7/16"
(11 mm)
7/16" (11 mm)
Quick-Connect
Terminals