Owner`s manual

To Add, Reprogram or Change a Key/ess Entry PIN
NOTE:Your new KeylessEntry must be programmed to operateyour garage door opener.
USINGTHE"LEARN" BUTTON
1. Pressand releasethe "learn" button on
motor unit. The learnindicatorlight will
glow steadilyfor 30 seconds.
2. Within 30 seconds,enter a four digit
personalidentificationnumber (PIN)of
your choiceonthe keypad.Then press
and holdthe ENTERbutton.
3. Releasethe buttonwhenthe motor unit
lights blink. It haslearnedthe code.If
light bulbsare not installed,two clicks
will beheard.
\1/
OneButtonC/ose:Openercan be closed by pressing only the
ENTERbutton if the one button close feature has beenactivated.
This feature has been activatedat the factory. To activateor
deactivatethis feature press and hold buttons 1 and 9 for 10
seconds. The keypadwill blink twice when the one button close is
active. The keypadwill blink four times when one button close is
deactivated.
To changean existing, knownPIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Pressthe four buttons for the present PIN, then press and hold
the # button.
The opener light will blink twice. Releasethe # button.
2. Pressthe new 4-digit PINyou have chosen, then press ENTER.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press ENTER.The door
should move.
Toset a temporaryPIN
You may authorize accessby visitors or service peoplewith a
temporary 4-digit PIN. After a programmed number of hours or
number of accesses,this temporary PINexpires andwill no
longer open the door. It can be used to closethe door even after
it has expired.To set a temporary PIN:
1. Pressthe four buttons for your personal entry PIN (not the last
temporary PIN), then press and hold the _, button.
The opener light will blink three times. Releasethe button.
2. Pressthe temporary 4-digit PINyou have chosen, then press
ENTER.
The opener light will blink four times.
3. To set the number of hoursthistemporary PIN will work, press
the number of hours (up to 255), then press _,.
OR
3. To set the number of timesthis temporary PINwill work, press
the number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN has been
learned.
Test by pressing the four buttons for the temporary PIN,then
press ENTER.The door should move. If the temporary PINwas
set to a certain number of openings, remember that the test has
used up one opening. To clear the temporary password, repeat
steps 1-3, setting the number of hours or times to 0 in step 3.
37