Owner`s manual

INSTALLINGTHE BRACKETS
Besure power to the openeris disconnected.Install and align
the brackets so the sensors will face each other across the garage
door, with the beam no higher than 6" (15 cm) above the floor.
They may be installed in one of three ways, as follows.
Garage doortrack installation (preferred):
• Slip the curved arms over the rounded edge of each door track,
with the curved arms facing the door. Snap into place against
the side of the track. It should lie flush, with the lip hugging the
back edge of the track (Figure 1).
If your door track will not support the bracket securely,wall
installation is recommended.
Waftinstallation(Figures2 and 3):
• Placethe bracket against the wall with curved arms facing the
door. Besure there is enough clearancefor the sensor beam to
be unobstructed.
• If additional depth is needed,an extension bracket (see
Accessories) or wood blocks can be used.
• Usebracket mounting holes as a template to locate and drill
(2) 3/16" diameter pilot holes on the wall at eachside of the
door, no higher than 6" (15 cm) above the floor.
• Attach brackets to wall with lag screws (not provided).
• If using extension brackets or wood blocks, adjust right and
left assembliesto the same distance out from the mounting
surface. Make sure all door hardware obstructions are cleared.
Floorinstallation(Figure4):
• Usewood blocks or extension brackets (see Accessories) to
elevatesensor bracketsso the lenseswill be no higher than
6" (15 cm) abovethe floor.
• Carefully measure and place right and left assembliesat the
same distance out from the wall. Besure all door hardware
obstructions are cleared.
• Fastento the floor with concrete anchors as shown.
Figure DOOR TRACK MOUNT (RIGHT SIDE)
Door
Track
\
Lip
S enskoert
Figure2
Figure3
js_z
WALL MOUNT (RIGHT SIDE)
Indicator
Light
iiiiiiii
iiiiiiii
iiiiiiii
iiiiiiii
iiiiiiii
iiiiiiii
WALL MOUNT (RIGHT SIDE)
Extension
Bracket
(See Accessories)
J.,,n (Provided with
nBracket
(Provided with
Extension ""
Bracket)
Lens
Sensor
Bracket
Indicator
Light
Figure4 FLOOR MOUNT (RIGHT SIDE)
Carriage Bolt
1/4" 20xl/2"
HARDWARESHOWN ACTUALSIZE
Wing Nut
1/4" 20
Staples
?-_ ttach with
Concrete Anchors
; (Not Provided)
Indicator
Light
Bracket
21