Owner`s manual

INSTALLATION STEP 7

Install the Battery

• Make sure motor unit is unplugged.

• Usinga Phillips headscrewdriver, removethe battery cover on

the motor unit.

• Partially insert battery into motor unit with terminals facing

out.

• Oonnectthe red (+) and black (-) wires from motor unit to

corresponding terminals on battery.

• Replacebattery cover.

ALWAYSwear protective gloves and eye protection when

changing the battery or working around the battery

compartment.

Battery

Battery Cover

INSTALLATION STEP 8

Install theLights

• Pressthe releasetabs on both sides of lens. Gentlyrotate lens

back and downward until the lens hinge is in the fully open

position. Do not removethe lens.

• Install up to a 100 watt maximum light bulb in each socket.

Light bulb size should be A19, standard neck only. The lights

will turn ON and remain lit for approximately 4-1/2 minutes

when power is connected.Then the lights will turn OFF.

• Reversethe procedure to close the lens.

• UseA19, standard neck garagedoor opener for replacement.

NOTE:Useonly standard light bulbs. The use of short neck or

speciafity light bulbs may overheatthe endpanel or light socket.

To prevent possible OVERHEATINGof the endpanelor light

socket:

• DONOTuse short neck or specialty light bulbs.

• DONOTuse halogen bulbs. UseONLY incandescent.

To prevent damage to the opener:

• DONOTuse bulbs larger than IOOW.

• ONLY use A19 size bulbs.

1O0 Watt (Max) -_,, ]

Standard Light Bulb

Release Tab /

H /

100 Watt (Max) _ Lens X ]

Standard i _k,,. ...... _ J

Light Bulb '_:- _,

.__9