Owner`s manual

Installation Step 4
Install the Safety Reversing Sensor
(Receiving and Sending Eyes)
Figures 1 and 2 show assembly of brackets and "C" wrap
based on the recommended installation of the sensors on
each side of the garage door as shown on page 16.
However, Figures 3 and 4 are variations which may fit
your installation requirements better. Make sure the
wraps and brackets are aligned so the sensors will face
each other across the garage door.
1. Fasten the "C" wraps to the mounting brackets having
square holes, using the hardware shown in Figure 3.
2. Connect each assembly to a slotted bracket, using the
hardware shown in Figure 2.
Note the alignment of the brackets for left and right
sides of the door.
3. Finger tighten the lock nuts.
4. Use bracket mounting holes as a template to locate and
drill (2) 3/16" diameter pilot holes on both sides of the
garage door, 4"-6" above the floor but not exceeding
6". (See warning on page 16.)
5. Attach bracket assemblies with 1/4"x1-1/2" lag screws
as shown in Figure 2.
6. Adjust right and left side bracket assemblies to the
same distance out from the mounting surface. Make
sure all door hardware obstructions are cleared.
Tighten the nuts securely.
Figure 1
#10 - 32
Lock Nuts
Mounting Bracket
With Square Holes
"C" Wrap
# 10-32x3/8"
Screws
Figure 2
1/4 x 1-1/2" 1/4-20 x 1/2" Carriage Bolts
Lag Screws (with square shoulder)
Inside ,.., --
_arage
Wall
i
*" _ Mounting Bracket ] "C" Wrap
._. Slot Mounting Bracket
. with Square Holes
J Lock Nuts20
Figure 3
Alternate Wall Mount
Inside
Garage
Wall T
Mounting Bracket
with Slot
Mounting Bracket
with Square Holes
"C" Wrap
with wire
Indicator Light
J
Figure 4
Alternate Floor Mount
InSide
Garage
Wall
Floor
Sensor with wire
Indicator Light
Mounting Bracket
with Square Holes
/
Mounting Bracket
/ with Slot
Attach with
._ (oncrete anchors
not provided)
#10 - 32 x 3/8"
Screw
©
#10 x 32
Lock Nut
Hardware Shown Actual Size
Lag Screw Staples
1/4" - 20 x 1/2"
Carriage Bolts
Q
1/4" - 20
Lock Nut
17