Owner's Manual

OPERATION
To inflate vehicle and bicycle tires:
1. Place 120 Volt Inflator evenly on flat
surface.
2. Connect the PVC coil air hose to the
Inflator by pulling back on the quick
connect coupler and inserting this onto
the valve located on the end of the 1
foot rubber air hose until you hear a
click to lock the PVC coil in place.
3. Connect the screw-on valve to tire air
valve by twisting clockwise until it is
securely attached to the tire air valve.
4. Plug the power cord into a grounded
120 Volt outlet.
5. Move the On/Off switch to the On
position and the Inflator will begin to
operate. Monitor the PSI on the gauge
to fill your item to desired pressure.
Once you have reached the desired air
pressure, move the On/Off switch to
the Off position.
6. To remove the air hose from your tire
air valve, twist the screw-on valve
counter clockwise.
7. Unplug the power cord from 120 Volt
outlet.
8. Remove the PVC coil from the Inflator
by pulling back on the quick connect
collar and pulling away from the valve
located on the end of the 1 foot rubber
air hose.
9. Allow unit to cool.
WARNING: Risk of Flying
Objects/Bursting Objects. Over
inflating tire could cause the tire to
burst or the screw-on valve to pop off
the valve stem and become a
projectile. Use a tire pressure gauge
to ensure an accurate tire pressure
reading, because the pressure gauge
on the unit is for general reference
only.
To inflate sports ball, air mattress,
rubber raft, etc.
1. Place 120 Volt Inflator evenly on flat
surface.
2. Connect the PVC coil air hose to the
Inflator by pulling back on the quick
connect coupler and inserting this onto
the valve located on the end of the 1
foot rubber air hose until you hear a
click to lock the PVC coil in place.
3. Select the appropriate inflation
accessory and screw onto end of the
PVC coil screw-on valve.
4. Plug the power cord into a grounded
120 Volt outlet.
NOTE: For instructions on how to
use High Flow Inflator/Deflator
Adaptor at this point, see the next
page.
5. Insert the inflation accessory into
desired item you are inflating.
6. Move the On/Off switch to the On
position and the Inflator will begin to
operate. Inflate your desired item to the
correct pressure and move the On/Off
switch to the Off position.
7. Remove inflation accessory from
screw-on valve.
8. Unplug the power cord from 120 Volt
outlet.
9. Remove the PVC coil from the Inflator
by pulling back on the quick connect
collar and pulling away from the valve
located on the end of the 1 foot rubber
air hose.
10. Allow unit to cool.
WARNING: Risk of Bursting.
Most sports balls with no initial air will
fill in less than 10 seconds. Watch
sports balls carefully while filling, do
not overfill.
WARNING: Risk of Bursting. Too
much air pressure causes a
hazardous risk of bursting. Check the
manufacturer’s maximum pressure
rating for objects being inflated.
Carefully follow instructions.
11