Owner`s manual

Place the threaded end of one cable through the

small hole in the tab at the front end of the pulley

track as shown. Wrap the cable one time around the

pulley and then push it through the hole in the tab at

the rear of the track.

While applying slight tension on the cable, with the

aid of pliers, install the 3/8 inch washer followed by

the 8-32 Hex Nut on the threaded end of the cable as

shown.

Repeat the cable installation on the other pulley.

Check for free movement of the pulleys. The pulleys

should not sJide on the tracks but roll freely without

any cable slippage. If additional cable tension is

needed, tighten the 8/32 Hex nut securing the cable

at the rear, while holding the body of the threaded

end with a pliers.

NOTE: The tension on the two cables should be

about equal. Check the tension on each by

"picking" the cable like a guitar string and listening

to the sound. Adjust the tension to make the two

sounds similar in pitch.

iV. INSTALLING THE ROUTER

(not supplied)

Step four requires the following:

ITEM DESCRIPTION

QTY.

A Router (motor assembly) .............. 1

B Router clamp , ........................ 1

C 1/4-20 x 1-1/4 pan head screws ........ 4

D 1/4-20 x t-1/2 round head screws ...... 1

E 1/4-20 Hex nut . ....................... 1

Your Router Recreator is designed to accept most

routers with a motor body from 3 inches to 3-3/4

inches in diameter. If your router does not easily

adapt to the router mount, it is not recommended

that you attempt any alteration of the mount or your

router.