Owner`s manual

de the Pulley shaft through the bearings at the

.rear of the Y0ke Assembly followed by the shaft

Collars _ one or1 each side of the Yoke as shown,

install 1/4 inchsetsCrew in thethreaded h01e in each

of the Collars. The Collars should not be

at this time.

Slide the 5 inch Track Pulleys o n to the Pulley Shaft

with the hub of the pulley (area which contains the

setscrew) facing toward the Yoke as shown. This

Shaft shoulc_ extend beyond the Pulleys

approximately 1/8 inch on each end.

Place the pulley hubs on the Shaft such that one

pulley set screw faces front while the other faces

rear as Shown. This wil! help insure access to one of

the set screws during future adjustments.

PULLEY HUB

SHAFT SHOULD EXTEND

BEYOND PULLEYS

APPROXIMATELY 1/8"

ON EACH END

PlaCe the entire yoke assembly on the frame with the

pulleys riding on the Track Brackets and the large

black Knob facing the front.

Loosen the pulley setscrews and push outward on

the pulley so that the tracks are riding on the inside

corners of the pulley grooves as shown. Tighten the

pulley setscrews. The Pulley Shaft should extend

beyond the faces of the pulleysan equal amount on

each side,

TRACK MUST RIDE

ON INSIDE EDGE

OF PULLEY GROOVE

Iii. CABLE ASSEMBLIES

For step three you'll need --

ITEM DESCRIPTION QTY:

A Steel Cables .......................... 2

B 8-32 Hex Nuts ..................... 2

C 3/t6 X 3/8 Flat Washers ............... 2

0))))))l)))})})--