Owner`s manual

l!. YOKE ASSEMBLY

Step two will require the following parts:

ITEM DESCRJPT|ON QTY,

A 5" Pulleys ............................. 2

B Pulley Shaft Collars ................... 2

C Socket Head Setscrews, I/4-20 x t/4" .. 2

D Pulley Shaft ........................... 1

E Yoke Sub-Assembly ................... 1

F Counterweight Shaft ................... 1

G Pan Head Screws, 10-32 x 3/4" . ........ 2

H Stylus Mount .......................... 1

J Large Knob ........................... 1

K Small Knob ........................... !

L Socket Head Setscrew, 5/16-18 x t/4" .. 1

Place the Counterweight Shaft inside the rear of the

Yoke with the bent section of the Shaft extending

out and upward. The two holes in the Shaft should

align with the two small holes in the Yoke as shown.

Secure it with the two 3/4 inch pan head screws,

COUNTER WEIGHT

SHAFT

YOKE ASSEMBLY

YOKE

BEARING

ROUTER MOUNT

STYLUS MOUNT

Screw the large and small Knobs and a 1/4 inch

setscrew into the Stylus Mount as shown.

Slide this assembly on to the Router Mount Shaft as

shown and lightly tighten the setscrew.

STYLUS

MOUNT

SETSCREW