Owner`s manual

Jld now be pbsSible to rotate the workpiece by
L9/16 wrench on theHex head bolt located
center wobble should be etectable. If the spindle
:is not secure in its mounting do not attempt to
operate until the necessary adjustments have been
made.
Mount the sketch on the back up board which is
installed on the left side of the Recreator.
Install a 1/4 inch stylus in the stylus mount.
Select a bit desired for the first cut and secure it in
the router chuck.
Move the yoke assembly on the pulley shaft until the
bit is approximately 1/4 inch off the centertine of the
spindle to the left. Lock the right hand putley shaft
collar against the yoke bearing to serve as a stop,
Rest the router bit on the spindle and check for
perpendicularity. If adjustments are required loosen
the tilt plate wing nuts and square as necessary.
Re-tighten the tilt plate wing nuts.
Move the bit to the area of the first cut as determined
by the drawing or template and lock the pulley shaft
at that location with the pulley shaft locks and wing
n uts.
Set the depth of cut by raising the stylus above the
back up board the desired amount.
Move the router bit tothe left of the spindle making
sure it is clear of the spindle.
f
ROTATE t"
COUNTER CLOCKWISE
f
/
/
/
Holding the stylus tip in contact with the back-up
board during the operation,tu rn the router on. using
a 9/16 box end wrench, Begin rotating the spindle
"counter clockwise" s_multaneousty start moving
the bit into the s pindle until it stops against the right
hand shaft collar.
After the cut is completed (usually several
revolutions of the spindle), back the bit away from
the spindle and turn the router off.
Move to the next desired location and repeat above
procedure.
To create axia cuts, those running along the length
of the spindle mount the spind e as indk_ated above
then:
Move the router bit to the centerline of thespindte
and lock the yoke at this setting by securing both left
hand and right hand shaft collars.
Set the depth of cut usi ng the stylus and the back up
board as a guide.
C-clamp the work mount to the front shelf board to
prevent _t from rotating.
Liftthe bit clear of the spindle, turn tt_e router on and
lower the bit into the spindle.
Move the yoke assembly back and forth until thecut
is €ompleted, Veins deeper than 1/8 of an inch
should be made in successive cuts of 1/8 inch.
J
/ jjj i
L
C-CLAMP WORK MOUNT_
TO PREVENT ROTATION O