Owner`s manual

i
operat on
iATIVE EDGING
A molded or decorative-edge can be added to most
rectangular shaped pieces of stock with your
" Recreator, a decorative edging bit and the router
work arbor set; i :
Set the two inner shelf boards as prescribed for sign
making,
Check :for parallelism between the Recreator and
the workpiece by us ng the pilot section of the work
arbor.
A. Touch the pilot to the edge of the workpiece at
the front of the Recreator.
B.-C-clamp the work_)iece to the shelf board and
set both left and right hand shaft collars.
C. Move the yoke assembly to the rear. Shift the
rear of the workpiece until it also strikes the pilot
section of the work arbor. C-clamp the rear of
the workpiece to the shelf board.
D. The depth of cut will be controlled by thestylus
riding on the back up board located on the left of
the Recreator. You will note that variations in the
molding can be obtained by altering the depth of
cut or by setting the workpiece slightly away
from the pilot of the work arbor.
\
WORK ARBOR
PILOT
Shaping cross grain can also be accomplished with
the aid of the shaft lock brackets.
OLE IN SHAFT BRACKET
LACED OVER END
OF PULLEY SHAFT