Owner`s manual

tn addition to the shaft lock collars, shaft lock

brackets are also provided. These can be slipped

under the outside tip of the pulley cover guards and

the hole in t:he bracket placed on the pulley shaft.

The opposite end of the bracket which is slotted can

be screwed to the corner track bracket with a 1/2

inch pan head screw, Iockwasher, and wing nut

These shaft lock brackets will immobilize the pulley

sh aft and only permit the yoke assem bly to travel left

to right or right to left. This is an excellent way to

produce straight line cuts from side to side. These

brackets are also helpful in securing your Router

Recreator when transporting.

SHAFT LOCK

COLLARS

After aligning the master and the workpiece, a

router bit and matching stylus suited for the

application should be selected and the elevation set.

If working from a drawing determine whether the

_etters are to be raised or recessed, and the amount

of recess or desired height of the letters. If a raised

Ietter is desired, raise the stylus above the drawing

the same height as the desired height of the letters.

A small scale or ruler is helpful in determining the

depth of cut. Route all areas around the letters

leaving the letter intact,

Smaller diameter bits and stylus may be required for

the detailing of more intricate lettering,

If recessed letters are desirable, simply trace the

letters with the stylus after the depth of cut has been

selected.

When duplicating a sign from an existing sign the

elevation of the stylus and bit should be the same.

If the sign requires some relief cutting or slight

undercuts, this can be accomplished by loosening

the tilt plate wing nuts, pivoting the yoke assembly

to the desired angle, and the resecuring the two

wing nuts.

RAISED

J LETTERS

RECESSED LETTERS

/ /