Owner`s manual

As the carving begins to take shape some undercut

work may be necessary. This can be accomplished

by loosening two wing nuts near the yoke tilt plate,

titting the yoke assembly to the desired angle and

then re-tightening the wing nuts. "Always turn the

router off when pivoting the yoke or making any

adjustment,"

TILT PLATE

WING NUTS

After the object is nearing completion you may find

it necessary to re-mount the master and workpiece

in a vertical plane rather than horizontal. This witl

allow the bit to contact the workpiece on the top and

base sections of the carving that were inaccessible

in the horizontal plane.

After the object has been completely carved it can

be finished in a number of ways, Some prefer the

rustic hand carved appearance that results from the

router bits while others prefer sanding by hand or

with a small hobby too[.