Owner`s manual

alignment
Slide the Yoke Assembly either left or right on the
p u[tey Shaft u ntit the Stylus in the route r centers on
the-righthand Set _afholes in the front Shelf Board.
While holding the router Stylus Rod in place,
(centeriine of righthand holes) loosen the Stylus
MoUnt sets_crews and slide the mount left or r ght
untd the secdnd Stylus aligns with the lefthand set
of h 01es.
If both of the Stylus Rods are not flush with the face
of the front Shelf Board atthe sametime, the pulleys
require adjustment.
/
/
/" j j/
J
0 /
_J
STYLUS TO BE CENTERED ON HOLES
AND FLUSH AGAINST SHELF FACE
Reaching under either one of the pulley cover
guards with the 5/32 setscrew wrench locate the
setscrew and loosen it sufficiently to allow the
put ey to rotate independent of the pulley shaft,
Note! Adjustment of only one pulley is necessary,
either the left or the r ght pulley may be adjusted.
Rol! the =Yoke Assembly back and forth on the
Tracks several times. This should bring the two
pulleys into unison. Check to determine if the
correction was made by again placing the Stylus
Rods aganst the front Shelf Board. If some
mis-aiignment is sti detected it may be necessary
to gently roll the rig3thand pulley forward while
sirfiultaneOusfy rolling the lefthand pulley rearward.
If this worsens the rots-alignment reverse the
procedure. Once the two Stylus are flush and
properly spaced (centered on hotes) tighten the
_)utley and Stylus Mo[mt setscrews securely. Make
sure that the Tracks are again riding on the inside
edge of the puJley grooves when making any pulley
adjustments.
I
!
!
!
Finally check for free movement of the Yoke
Assembly on the Tracks.
If the pulleys slip on the Tracks additional cable
tenston may be required. This is done by tightening
the 8/32 nut at the rear of the Cable Assembly.
tf the pulley seems to bind on the Tracks the Cables
may be excessively tight or the pulleys may not be
riding on the inside edge of the pulley groove, if
necessary, adjust accordingly.
/
If the Yoke Assembly does not slide freely from side
to side.: lubrication of the pulley shaft may be
required. Silicon spray or graphite provi0e excellent
|egricat On and wil! not attract sawdust.
If the: yoke assembly does not slide freely after
lubrication; the. bearings may be slightly
misaligned. Rap :the yoke Sharply above the
bear rigs with _he beet of the hand torealign the
bearings.
/
/