Owner`s manual

.'H

Vl. INSTALLING THE PULLEY GUARDS

Parts required --

2 ea Pulley Guards

Loosen the 1/4-20 x 1-1/4 inch pan head screw

located at the top of each corner of the frame

assembly.

Remove the 1/4-20 x 1/2 inch pan head screw and

1/4-20 Hex nut from the top of each corner of the

frame assembly.

Place the pulley cover over the pulley and align the

slot at the front of the guard with the 1-1/4 inch pan

head screw and re-install the 1/2 inch pan head

screw through the holes in the side of the guard.

then through the Corner Track Brackets.

Tighten=the four pan head screws.

Repeat the pulley guard installation with the

remaining guard.

Run the pulley and yoke assembly back and forth to

make sure that the pulleys do not drag on the inside

of the covers. It may be necessary to loosen the

screws and shift the covers slightly to clear the

pulleys.

LOOSEN

VII. MOUNTING YOUR ROUTER

RECREATOR TO A STAND

To insure safe accurate operation it is important that

the frame of your Router Recreator is fastened to a

suitable table or leg set.

if you fashion your own leg set, remember to

provide access to center of the unit and sufficient

clearance of the corner brackets for the positioning

of the shelf boards.

NOTE: The recommended ieg set for the router

recreator is catalog no. 9-22238.

NOTE: See page 2 & 3 of instructions for catalog no.

9-22238 leg set and assemble the legs according to

trle section headed "For Bases Measuring 24" x

27"."

IMPORTANT: You must attach the side stiffeners to

the outside faces of the legs as shown m this

illustration.

ATTACH SIDE STIFFENERS

TO OUTSIDE FACES

OF THE LEG

FRONT

STIFFENER