Operator`s manual

The following parts are included with model
113.198411:
A°
B.
C.
D.
E.
F.
G.
H.
I.
J.
Basic Saw Assembly ............... 1
Operator's Manual ................ 1
Cabinet Box ...................... 1
Loose Parts Bags ................. *7
Trim Caps ....................... 2
Trim Ledge ...................... 1
Rear Table ....................... 1
Spacer ........................... 1
Fence ........................... 1
Front Table ...................... 1
*Note: This is the total number of loose parts
bags. One of these is packed inside the
Cabinet Box, and four are packed inside a
larger loose parts bag.
G
A
H
J
Fig. 11 - Parts for Model 113.198411
2. Identify the large parts of your saw before
beginning each section. Your task will be
easier if you are familiar with these parts.
3. Identify the tools required for assembly.
Make sure that you have all of the tools you
will need. (Figure 12)
7/16" Wrench
1/2" Wrench
9/16" Wrench
3/4" Socket
9/16" Socket
7/16" Socket
Socket Extension
Socket Wrench
Medium Screwdriver
#2 Phillips Screwdriver
Pliers
Framing Square
Pencil
1/8" Hex "L" Wrench
3/16" Hex "L" Wrench
Fig. 12 -Tools Required
4. Open the loose parts bags, and sort the
contents into piles on the floor or table. This
will make it easier for you to find the part(s)
you need during assembly.
The following loose parts are included with
model 113.198611:
A.
B.
C.
D.
E.
Drawer Fasteners ................ 48
Truss Head Bolts 1/4-20xl/2 ....... 82
Hex Nuts 1/4-20 ................. 82
Lockwashers 1/4 ................. 82
Phillips Head Screws 1/4xl/2 ....... 8
F.
G.
H.
I.
J.
K.
L.
M.
N.
Rods ............................ 2
Levers ........................... 2
Washers ......................... 2
Springs .......................... 2
Smooth Pins ...................... 2
Grooved Pins ..................... 2
Retaining Plates .................. 2
Actuator Boxes ................... 2
Phillips Itead Screws 10-32x3/8 ..... 4