Operator`s manual

Fig. 97
Leveling Front Table.
The goal of this adjustment is to make the
front work table flat and parallel to the radial
arm. In order to do this, you will choose four
points on the table. When these four points
are level, the entire table should be level.
You will use two methods to make the four
points level:
1. Loosen the three leveling screws and be
sure that the five mounting screws are snug
but not overtightened.
2. Raise the radial arm until the bottom of
the motor is about 2-1/2 inches above the
front table.
3. Unlock the bevel lock to release the motor.
Hold onto the motor as you do this.
_1_ CAUTION: The motor is heavy and
can swing down quickly. You can be cut
or injured if the arbor shaft hits you.
Hold the motor when you unlock the
bevel lock.
4. Turn the motor until the arbor shaft is
pointing straight down toward the table.
(Figure 99)
.Tighten the mounting screws which pull
down on the table making a given point
lower. (Figure 98)
,Tighten the leveling screws which push
up on the table making a given point
higher. (Figure 98)
eli 5 Mounting ° ° _1!e
Screws __I_ Leveling Screws
• /
O
i
Fig. 98
Fig. 99
5. Lock the bevel lock to hold the motor in
this position.
6. Draw two lines on the front table, over the
table rails. (Figure 99)
7. Unlock the rip lock and pull the motor out
to the end of the arm.
36