Operator`s manual

7. Place the front table on the saw so that the
mounting screws' line up with the U-clips. The
front table should extend about one inch
beyond the trim caps.
8. Start the mounting screws into the U-clips
using a Phillips screwdriver. Tighten the
screws until the heads are just touching the
table. Make sure that the table is not squeez-
ing the rubber grommets.
9. Start the leveling screws into the leveling
holes using a 1/8 inch Hex-L wrench. Tighten
the screws until they are flush with the table.
Putting Drawers in Place
Model 113.198611
1. Slide each drawer in place on the slide
brackets and push them all the way in.
2. Then pull each drawer out as far it will go.
The drawers should not come all the way out.
3. If any of the drawers do come all the way
out, use a screwdriver to bend out the stop
tabs on the slide brackets. (Figure 84)
10. Attach the left rod to the left table rail
with a hex head bolt and flat washer. Then
put another washer and a locknut on the bolt, I "_"
and tighten using two 1/2 inch wrenches or
sockets. (Figure 83)
/
Stop Tab
Left Table Rail
Center Slide Outer Bracket
1 1
Stop Tab Stop Tab Rear Stop
Fig. 84 - Stop Tabs
\
Fig. 83
11. Repeat step 10 with the right table rail.
12. Ifyou have model 113.198611, go to next
section, or
If you have model 113.198411, go to Location
and Function of Controls section.
4. Try the drawer again.
5. Repeat until none of the drawers fall out.
Removing Drawers
Model 113.198611
If you need to remove a drawer for any
reason, do the following:
1. Use a screwdriver to push in one of the
stop tabs on the right slide bracket. Pull the
drawer out slightly as you do this.
2. Repeat with the left slide bracket and pull
the drawer all the way out.
30