Operator`s manual

D
A
B
1 E
Fig. 78 - Parts for Mounting Table
1. Place a tee nut over each of the leveling
holes and hammer them into place.
(Figure 79)
U-Clips
/U-Clip On
_Center Channe
U-Clips
Fig. 80
3. Slide one U-clip over the hole in the left
side of the center channel as shown.
(Figure 80)
4. Put a washer on each of the mounting
screws. (Figure 81)
Fig. 81 - Mounting Screw and Washer
Mounting
Holes
Leveling Holes
Mounting Holes
Leveling Hole
Front Table - Upside Down
Fig. 79 - Leveling and Mounting Holes
2. Slide four U-clips over the holes in the saw
as shown. (Figure 80)
5. Stand the front table on one edge.
6. Put a mounting screw through each of the
mounting holes. Then put a rubber grommet
on the bottom of each mounting screw.
(Figure 82)
_,.._,. Table Rail _/
Rubber _-% Table Rail -----"lll_
GrommetIt,I _ /
_'_ __nti £g Holes/
t _Moon,ing .o,e_J _
I Holes o \
'_Front Edge
Fiq. 82
29