Operator`s manual

\
Fig. 75
Square Hole
Lock Handle With
Mounting Underneath
3. Slide the rod through one of the square
holes in the front of the saw. Then put the
hex head bolt through the round hole above
it. (Figure 75)
4. Put another lockwasher and a hex nut on
the bolt and tighten with a 7/16 inch wrench
or socket.
5. Repeat steps 1 - 4 on the other side of the
saw.
6. Turn the front table (44" x 17") upside
down. The top of the front table has five large
holes and seven smaller ones. This side
should be toward the floor.
7. Place the two table rails on the front table
as shown. The tabs should point toward each
other when both rails are in place, and the ec-
centric circles should be toward the floor.
(Figure 76)
Eccentric Circle
Eccentric
Circle Tab
Slide Button
Rail
Slide
Front Table - Upside Down
Fig. 76
8. Push a slide button through the small hole
in front of the eccentric circle on each table
rail.
9. Fasten the table rails to the front table
using four pan head screws and flat washers.
Tighten with a Phillips screwdriver.
(Figures 76 & 77)
Fig. 77 - Pan Head Screws and Washers
Mounting the Front Table
Both Models
The following parts are used to mount the
front table:
A.
B.
C.
D.
E.
F.
Tee Nuts ......................... 3
U-Clips 1/4-20 .................... 5
Mounting Screws 1/4-20xi-3/4 ...... 5
Rubber Grommets ................ 5
Hex Head Bolts 1/4-20x5/8 ......... 2
Washers 17/64-5/8xl/32 ............ 5
28